AQ: Self Excited Induction Generator (SEIG)
The output voltage and frequency of a self excited induction generator (SEIG) are totally dependent on the system to which it is attached.
The fact that it is self-excited means that there is no field control and therefore no voltage control, instead the residual magnetism in the rotor is used in conjunction with carefully chosen capacitors at its terminal to form a resonant condition that mutually assists the buildup of voltage limited by the saturation characteristics of the stator. Once this balance point is reached any normal load will cause the terminal voltage to drop.
The frequency is totally reliant upon the speed of the rotor, so unless there is a fixed speed or governor controlled prime mover the load will see a frequency that changes with the prime mover and drops off as the load increases.
The above characteristics are what make SEIGs less than desirable for isolated/standalone operation IF steady well regulated AC power is required. On the other hand if the output is going to be rectified into DC then it can be used. Many of these undesirable “features” go away if the generator is attached to the grid which supplies steady voltage and frequency signals.
The way around all the disadvantages is to use a doubly fed induction generator (DFIG). In addition to the stator connection to the load, the wound rotor is provided with a varying AC field whose frequency is tightly controlled through smart electronics so that a relatively fixed controllable output voltage and frequency can be achieved despite the varying speed of the prime mover and the load, however the costs for the wound rotor induction motor plus the sophisticated control/power electronics are much higher than other forms of variable speed/voltage generation.
